|
OBD - Onboard diagnostics |
| Bosch (Knorr) ABS/ASR CI 12 4S/4K |
| |
|
|
Read out fault memory |
|
Prerequisites: |
|
- Vehicle at standstill
- Turn system selector switch to ABS position (see electrical key)
- Drive switch off and on again = Reset (drive switch to step 2, drive position)
|
|
Fault output via ASR info lights (yellow): |
|
- Hold down check key (red) for at least two seconds. The configuration is output.
- Then hold down check key again for at least two seconds.
|
|
Notes: |
- Each fault is output in three blocks (hundreds, tens, units), which are separated from one another by a pause (approx. three seconds).
- If a number of faults is stored, then these will be output in the chronological order in which they occurred, and each fault must be called up individually using the check key.
|
|
|
|
Setting up the flashing sequence (ASR lights or INA) using an example: |
|
|
|
|
0 |
|
ASR lights off |
1 |
|
ASR lights on |
2 |
|
Release check key |
3 |
|
Check key held down |
|
4 |
|
three second pause |
5 |
|
Configuration code (in example => 2) |
6 |
|
most recent stored fault (in example => 312) |
7 |
|
fault prior to most recent stored fault (in example => 322) |
|
|
|
|
Clear fault memory |
|
|
- Press and hold down the check key with the drive switch at off,
- switch on the drive switch (step 2, drive position),
- release the check key after at least two seconds.
|
|