| FE | 0001 | Rectifier part of traction motor:Temperature sensor is faulty. |
| FE | 0002 | Rectifier part of traction motor:Excess temperature at heat sink (> 85 °C) |
| FE | 0004 | Rectifier part of traction motor:Excess temperature at controller hardware |
| FE | 0006 | Rectifier part of traction motor:Excess temperature at cable semiconductor |
| FE | 0007 | Rectifier part of traction motor:Temperature sensors faulty(Path 00 - 10) |
| FE | 0011 | Rectifier part of traction motor:CAN controller was too often in Bus OFF state. |
| FE | 0020 | Rectifier part of traction motor:The actuation element of the brake resistor is faulty.(The 24 V supply may be faulty.) |
| FE | 0021 | Rectifier part of traction motor:The actuation element of the rectifier is faulty.(The 24 V supply may be faulty.) |
| FE | 0022 | Rectifier part of traction motor:Overvoltage |
| FE | 0023 | Rectifier part of traction motor:Undervoltage |
| FE | 0024 | Rectifier part of traction motor:Excess current |
| FE | 0025 | Rectifier part of traction motor:Short circuit |
| FE | 0026 | Rectifier part of traction motor:Current detection fault at traction motor |
| FE | 0030 | Rectifier part of traction motor:15 V supply is not within the permissible range. |
| FE | 0031 | Rectifier part of traction motor:EEPROM error |
| FE | 0032 | Rectifier part of traction motor:Fault when reading the EEPROM |
| FE | 0033 | Rectifier part of traction motor:Fault when writing the EEPROM |
| FE | 0034 | Rectifier part of traction motor:EEPROM does not respond to the slave address. |
| FE | 0035 | Rectifier part of traction motor:The write access to EEPROM takes place without logon. |
| FE | 0037 | Rectifier part of traction motor:Checksum error when block reading the EEPROM |
| FE | 0038 | Rectifier part of traction motor:Checksum error in the case of the SIADIS parameters |
| FE | 0039 | Rectifier part of traction motor:RAM test was unsuccessful. |
| FE | 0040 | Rectifier part of traction motor:The fault memory of the FE Drive electronics control module is faulty. |
| FE | 0041 | Rectifier part of traction motor:Fault in the programmable logic element |
| FE | 0042 | Rectifier part of traction motor:Flash checksum error |
| FE | 0043 | Rectifier part of traction motor:High speed link between the two rectifiers is faulty. |
| FE | 0044 | Rectifier part of traction motor:24 V supply is not within the permissible range. |
| FE | 0050 | Rectifier part of traction motor:Time monitoring error in program run |
| FE | 0051 | Rectifier part of traction motor:Illegal software command |
| FE | 0052 | Rectifier part of traction motor:Stack overflow |
| FE | 0053 | Rectifier part of traction motor:Overflow in the 1ms time slice |
| FE | 0054 | Rectifier part of traction motor:Overflow in the 10ms time slice |
| FE | 0055 | Rectifier part of traction motor:Overflow in the 100ms time slice |
| FE | 0076 | Rectifier part of traction motor:Unrectifiable rectifier shutoff |
| FE | 0099 | Rectifier part of traction motor:General system error |
| FE | 1001 | Rectifier part of generator:Temperature sensor is faulty. |
| FE | 1002 | Rectifier part of generator:Excess temperature at heat sink (> 85 °C) |
| FE | 1004 | Rectifier part of generator:Excess temperature at controller hardware |
| FE | 1006 | Rectifier part of generator:Excess temperature at cable semiconductor |
| FE | 1007 | Rectifier part of generator:Temperature sensors faulty(Path 00 - 10) |
| FE | 1011 | Rectifier part of generator:CAN controller was too often in Bus OFF state. |
| FE | 1020 | Rectifier part of generator:The actuation element of the brake resistor is faulty.(The 24 V supply may be faulty.) |
| FE | 1021 | Rectifier part of generator:The actuation element of the rectifier is faulty.(The 24 V supply may be faulty.) |
| FE | 1022 | Rectifier part of generator:Overvoltage |
| FE | 1023 | Rectifier part of generator:Undervoltage |
| FE | 1024 | Rectifier part of generator:Excess current |
| FE | 1025 | Rectifier part of generator:Short circuit |
| FE | 1026 | Rectifier part of generator:Current detection fault at generator |
| FE | 1030 | Rectifier part of generator:15 V supply is not within the permissible range. |
| FE | 1031 | Rectifier part of generator:EEPROM error |
| FE | 1032 | Rectifier part of generator:Fault when reading the EEPROM |
| FE | 1033 | Rectifier part of generator:Fault when writing the EEPROM |
| FE | 1034 | Rectifier part of generator:EEPROM does not respond to the slave address. |
| FE | 1035 | Rectifier part of generator:The write access to EEPROM takes place without logon. |
| FE | 1037 | Rectifier part of generator:Checksum error when block reading the EEPROM |
| FE | 1038 | Rectifier part of generator:Checksum error in the case of the SIADIS parameters |
| FE | 1039 | Rectifier part of generator:RAM test was unsuccessful. |
| FE | 1040 | Rectifier part of generator:The fault memory of the FE Drive electronics control module is faulty. |
| FE | 1041 | Rectifier part of generator:Fault in the programmable logic element |
| FE | 1042 | Rectifier part of generator:Flash checksum error |
| FE | 1043 | Rectifier part of generator:High speed link between the two rectifiers is faulty. |
| FE | 1044 | Rectifier part of generator:24 V supply is not within the permissible range. |
| FE | 1050 | Rectifier part of generator:Time monitoring error in program run |
| FE | 1051 | Rectifier part of generator:Illegal software command |
| FE | 1052 | Rectifier part of generator:Stack overflow |
| FE | 1053 | Rectifier part of generator:Overflow in the 1ms time slice |
| FE | 1054 | Rectifier part of generator:Overflow in the 10ms time slice |
| FE | 1055 | Rectifier part of generator:Overflow in the 100ms time slice |
| FE | 1071 | Rectifier part of generator:Signals from the DNR pushbutton switch are internally wrongly transmitted. |
| FE | 1076 | Rectifier part of generator:Unrectifiable rectifier shutoff |
| FE | 1099 | Rectifier part of generator:General system error |
| FE | 2001 | Generator:Temperature sensor is faulty. |
| FE | 2005 | Generator:Excess temperature (possible failure of current limiter) |
| FE | 2075 | Generator:Engine overspeed |
| FE | 3001 | Engine:Temperature sensor is faulty. |
| FE | 3005 | Engine:Excess temperature (possible failure of current limiter) |
| FE | 3074 | Engine:Rotary sensor fault |
| FE | 3075 | Engine:Engine overspeed |
| FE | 4001 | Brake resistor:Temperature sensor is faulty. |
| FE | 4003 | Brake resistor:Excess temperature at braking resistor |
| FE | 4072 | Brake resistor:Resistance is too high.(Cable break) |
| FE | 4073 | Brake resistor:Resistance is too low.(Short circuit) |
| FE | 5070 | DNR pushbutton:Signal read in from DNR pushbutton is implausible. |
| FE | 6010 | NOT ASSIGNABLE:No CAN values received for excessively long time |
| FE | 6011 | NOT ASSIGNABLE:CAN controller was too often in Bus OFF state. |
| FE | 6060 | NOT ASSIGNABLE:Backup processor is not active. |
| FE | 6061 | NOT ASSIGNABLE:The drive status is within the forbidden quadrant. |
| FE | 6062 | NOT ASSIGNABLE:The 'DRIVE' specified status is not maintained. |
| FE | 6063 | NOT ASSIGNABLE:The 'BRAKE' specified status is not maintained. |
| FE | 6064 | NOT ASSIGNABLE:Implausible accelerator pedal set value |
| FE | 6065 | NOT ASSIGNABLE:Implausible brake pedal set value |
| FE | 6066 | NOT ASSIGNABLE:The specified status IDLE SPEED is not maintained. |
| FE | 6067 | NOT ASSIGNABLE:Unauthorized crawling |
| FE | 6068 | NOT ASSIGNABLE:Safety relay jamming. |
| FE | 6071 | NOT ASSIGNABLE:Signals from the DNR pushbutton switch are internally wrongly transmitted. |