|
OBD - Onboard diagnostics |
| Bosch ABS/ASR Gamma III 6S/6K |
| | |
| |
|
| Read out fault memory |
|
| Prerequisites: |
|
- Vehicle at standstill
- Turn system selector switch to ABS (1) position (see electrical key)
- Drive switch off and on again = Reset (drive switch to step 2, drive position)
|
|
| Fault output via ASR info lights (yellow): |
|
- Hold down check key (red) for at least two seconds. The configuration output is shown in two blocks, followed by the diagonal 1 fault code output in the third block and diagonal 2 in the fourth block.
|
|
| Notes: |
- Diagonal 1 (third block) corresponds to 1L/2R/3L (first shaft left wheel/second shaft right wheel/third shaft left wheel).
- Diagonal 2 (fourth block) corresponds to 1R/2L/3R (first shaft right wheel/second shaft left wheel/third shaft right wheel).
- Only one fault can be read out via the flashing code for each diagonal; this means: The most recent fault is always indicated.
|
|
|
| |
| Setting up the flashing sequence (ASR lights): |
|
|
 |
|
| 0 |
|
ASR lights off |
| 1 |
|
ASR lights on |
| 2 |
|
Hold down the check key for at least 2 seconds |
| 3 |
|
ASR lights 1 second off (pause until the first block) |
| 4 |
|
Output first block (Configuration code) |
| 5 |
|
ASR lights 1.5 seconds off (pause until the next block) |
| 6 |
|
Output first block (Configuration code) |
|
| 7 |
|
ASR lights 1.5 seconds off (pause until the next block) |
| 8 |
|
Output third block (Fault code toDiagonal 1) |
| 9 |
|
ASR lights 1.5 seconds off (pause until the next block) |
| 10 |
|
Output fourth block (Fault code toDiagonal 2) |
| 11 |
|
End of flashing sequence |
|
|
| |
|
| Clear fault memory |
|
|
- Press and hold down the check key with the drive switch at off,
- Switch on the drive switch (step 2, drive position),
- release the check key after at least two seconds.
|
|
|
| |
|
