|
OBD - Onboard diagnostics |
| Bosch ABS/ASR Gamma II 4S/4K |
| |
|
|
Read out fault memory |
|
Prerequisites: |
|
- Vehicle at standstill
- Turn system selector switch to ABS (1) position (see electrical key)
- Drive switch off and on again = Reset (drive switch to step 2, drive position)
|
|
Fault output via ASR info lights (yellow): |
|
- Hold down check key (red) for at least two seconds. The configuration output is shown in the first block, followed by the diagonal 1 fault code output in the second block and diagonal 2 in the third block.
|
|
Notes: |
- Diagonal 1 (second block) corresponds to 1L/2R (first shaft left wheel/second shaft right wheel).
- Diagonal 2 (second block) corresponds to 1L/2R (first shaft right wheel/second shaft left wheel).
- Only one fault can be read out via the flashing code for each diagonal; this means: The most recent fault is always indicated.
|
|
|
|
Setting up the flashing sequence (ASR lights): |
|
|
|
|
0 |
|
ASR lights off |
1 |
|
ASR lights on |
2 |
|
Hold down the check key for at least 2 seconds |
3 |
|
ASR lights 1 second off (pause until the first block) |
4 |
|
Output first block (Configuration code) |
5 |
|
ASR lights 1.5 seconds off (pause until the next block) |
|
6 |
|
Output second block (Fault code to diagonal 1) |
7 |
|
ASR lights 1.5 seconds off (pause until the next block) |
8 |
|
Output third block (Fault code to diagonal 2) |
9 |
|
End of flashing sequence |
|
|
|
|
Clear fault memory |
|
|
- Press and hold down the check key with the drive switch at off,
- Switch on the drive switch (step 2, drive position),
- release the check key after at least two seconds.
|
|